ENDLESS Heat for Your Home WITHOUT Electricity

Endless Heat for Your Home Without Electricity. We watched a YouTube video and got inspired to build our own convection heater that can heat up our 220 square foot cabin while only burning oil candles. The original video (https://www.youtube.com/watch?v=6ZnayOUQN28) is heating up a very small space with only four candles that eventually burn down too low and have to be adjusted or replaced. We are using oil with ten candle wicks which will remain burning at the same height even if the oil container runs low. We used JB weld to join all of the pieces together. This is what your heater should look like. We had someone make us a piece of high heat resistant oven glass which we installed over a high heat resistant gasket. We installed a second gasket on the inside to seal the door. We are using a concrete board as a fire resistant material which we painted black and installed onto the wall. We 3d printed this support for a standard computer fan which will be used as blower for our heater. We used a metal container as an oil storage container. We installed a small window so that we can monitor the level of the oil. We are using ten braided oil lamp wicks. We will install our heater in our 220 sq. foot cabin which is approximately the same size as two standard bedrooms at 10 ft. X 11 ft. A cold from came through and the temperature dropped. We are using steel gutters for our heater. First, we are tracing out four different holes that need to be cut out. We are removing the rubber seal which will be replaced with a heat resistant gasket. We built an oil lamp convection heater that can heat up a two bedroom cabin for less than $5 a week. The heater can reach up to a temperature of 500 degrees Fahrenheit. The heater can work on different kinds of oils which can be purchased very inexpensively at a wholesale price of $2.50 a gallon. Winter is approaching and running a space heater is an expensive option so we want to replace it with our convection heater. We are using a 50 caliber metal ammo box for this project. The computer fan runs at only twelve volts DC and 1.6 amps. It can also run on a twelve volt DC battery. The fan is very efficient in circulating the air through the heater to quickly heat up the space. It also keeps the heater cooler while operating. The heater also works as a lamp, giving off light in the night. The cool feature this heater has is that it gives the appearance of a natural gas fire place. The thickness and length of the wick and the level of oil in the storage container can affect the intensity of each flame. If the wick is too long, it will produce a lot of smoke and soot and a lot of unburned fuel. That being said, things need to be properly adjusted. Also, different oils will produce different results. If you’ve made it to this point, please subscribe to the channel. I would really appreciate it as it helps support me make new videos just like this one. All the parts for this project were about $100 combined. Most of these parts were purchased from a regular hardware store. The ammo box was purchased on Amazon. We are very impressed with the final outcome of the heater. It performs a lot better than what we imagined. We ran the heater every day, for seven days, twelve hours a day. Each time, the oil level on the storage container drops about 1/2-3/4”. The storage container can hold half a gallon of oil, and it takes approximately a week to go through a whole gallon of oil. The heater is giving off a tremendous amount of heat.
Website: mindoftesla.com